Klicky Usermods

## Native KlickyNG Mantis Xcarriage (MGN12H) including Dock by Minsekt

This is a modified Mantis Xcarriage to fit KlickyNG based on KayosMaker’s Klicky X-Carriage. there’s also a Carriage included that supports a LGX Lite.

## Native UnklickyNG (6x3) Mantis Xcarriage (MGN12H) including Dock by Minsekt

Modified Mantis Xcarriage for the UnklickyNG 6x3 including a fitting dock. this one is just as lightweight as the stock mantis Xcarriage!

## Klicky Probe with additional holes by StefanRaatz

This is a modified Klicky probe with two holes so that you can feed through the uninsolated part of the cable a little bit more. Gave me better contact

## KlickyVoron 2.4 Direct Mount MGN12 X Carriage by bluedragonx

This is a modified MGN12 X carriage for the Voron 2.4 which directly interfaces with the Klicky. This is based on Arkeet’s MGN12 carriage

## More Roboust Klicky Probe by oc_geek

Beefier column and revised holes for zip tie (was def too small); reduced height 1mm (was excess) Chanfered bottom in all direction (also sides) on the probe carriage Microswitch body exposed by a tiny bit

## Fixed gantry Klicky dock mount for Legacy by Baltojikale

Meanwhile included in the main project files

## Adjustable Klicky dock mount for Legacy by Maverick

Modified Klicky Probe to mount on a Voron Legacy. Docking components are designed to allow for adjustments on the Z and Y axis.

## Modded Z endstop for v1.8 by Yeri

Designed for V1.8 “I had originally used the z endstop in the stock position but due to the crashes with the probe attached I extended it in Y by 14 mm – here’s the new stl”

## Fixed Side Dock mount for Trident by Mneuhaus

“The 2.4 Dock and Variable Dock take up quite a lot of space which could be better used for nozzle scrubbing etc. I’ve created an alternative Dock, that attaches to the rear left vertical profile.” It’s compatible with the Klicky v2 dock

## Dock mount fixed S by Fiction

“A dock mount that can be positioned closer to the end of the V2 or Trident rear gantry extrusion to avoid the nozzle brush, without using a side mount. It also puts the dock 2.5mm forward (i.e. in the negative y direction) which was necessary for my setup.”

## Retractable Probe Dock by Tron Fu

A Servo-powered Retractable Dock for Klicky Probe and Nozzle Brush.

## Another Roboust AB/SB mount by sporkus

Tested on MGN12 carriage from V2.4. Mounts with M3x20 SHCS.

• Internal wiring groove. No need for zip tie.
• Prints flat on the back. Magnet bed is a vertical face, not bridged surface, may improve installed flatness.
• Eyebrows o\ /o

## X Carriage Probe Bracket for Klicky by EAMARS

• Fix the Klicky mount in place without too much stress.
• Tested only against MGN12 X Carriage.